-
The release agent is applied onto the mould. -
For the production of high-quality, smooth, form-finished concrete.
Smooth, form-finished concrete surfaces are “sensitive souls”. The concrete mix designs, the production process, ambient conditions and many other factors affect the success of the smooth, fair-faced concrete project. Admittedly, some of these parameters are very difficult to control. What is relatively easy to control and define, is the choice of the mould release agent, which also has a decisive influence on the surface quality of the concrete skin. Discolouration and micro-pores are often caused due to the use of an unsuitable release agent (demoulding oil) and/or by a wrong application of this product. So: it has to be a high quality concrete release agent, designed and made for smooth, form-finished concrete – no excuse!
HEBAU’s high performance mould release agents
WABICON® HP for best concrete surface skin quality, water-based. Suitable for smooth, form-finished (off board) concrete produced in smooth or structured moulds of all kinds (steel, rubber, coated wood …). Can be used in precast operations, as well as on construction sites using ready-mixed concrete.
WETCAST-FormFluid HP for best concrete surface skin quality, water-based. Designed for prefabricated decorative concrete, which are made in sensitive plastic or rubber moulds (ABS, PU, silicone, latex etc.) where oftenly concrete with self-compacting characteristics is used.
Advantages:
- best concrete surface skin quality.
- the durability of the mould is increased and the time
- for best concrete surface skin quality
- requirement to clean the mould is reduced to a minimum.
- easy to apply and spray
In general: When applying demoulding agents a low consumption rate and to apply only a thin film are best for the quality of the concrete surface.