That's how easy it is
We keep saying that using our CSE® deactivator is “very easy”, because it is! In this short video we prove it. In just 2 minutes we will show you how to apply our CSE® Deactivator perfectly for a “negative application”. For this demo we used our water-based CSE® “nova” and created a micro exposed aggregate concrete surface - see for yourself!
Simple and Concise - instructions
- Apply CSE® nova evenly to the mould with a roller
- Allow CSE® Deactivator to dry
- Mix concrete
- Pour, compact and smoothen concrete
- Allow concrete to cure for approx. 24 hrs
- Carefully remove the mould
- Wash out the deactivated concrete surface
- Here you go -The result shows a micro-exposed aggregate concrete surface
- Allow concrete to dry and admire the result
At the end of the video, we show how easy it is to clean the mould after using the CSE® Deactivator. In just a few steps the concrete mould is cleaned and ready for reuse. All you need is water, a brush and a cloth.
The detailed technical explanation can be found in the appropriate technical data sheet as well as in our How-to-Use Guides. We have a selection for you to download and try it out.
Downloads CSE® Deactivator
Further data sheets for all versions as well as further CSE® How-to-Use-Guides (e.g. positive application) can be found in our download section.
Do you have questions about our CSE® deactivators or the negative-application? Then don't hesitate to contact us. Our experts will advise you on your project.